Demolition, structural removal or excavation: NYC DOB BC 3304.4,27-1032 / OATH summons 39203085L
Original inspector allegation — verbatim available export
FAILURE TO PROVIDE PROTECTION AT SIDES OF EXCAVATION. AT TIME OF INSPECTION, OBSERVED NO SHORING FOR EXCAVATED PIT/BERM APPROX. 5'FT(L) X 20'FT(W), AND 8'FT DEEP LOCATED AT REAR YARD OF THE BUILDING EXPOSURE 3.
Source limit: Source reference: NYC OATH/DOB summons 39203085L; BIN 3020980; export issue date 09/03/2026. The earlier export status was ACTIVE; obtain current status from DOB or OATH. The CSV contains a respondent mailing address, which is not presumed to identify the inspected property. This is the entire description available in the supplied export, not a certified full summons, inspector notes or evidentiary exhibits. The description is at the export’s approximately 210-character field limit and may terminate mid-word or mid-sentence.
Get the complete, authentic notice: search summons 39203085L in OATH Summons Finder instructions (download actual summons) and download the actual summons; review DOB records in NYC DOB records search. Never substitute the editorial discussion below for the inspector’s words.
Charge classification: law controls; keywords do not
Recorded citation: BC 3304.4,27-1032; recorded infraction: 110. Primary legal issue: construction site safety and protection. Interpretive issue: Building Code provision, edition-specific. The cited Building Code provision is a technical construction/safety rule. The abbreviated dataset label does not supply the full legal elements.
What must be tested: Retrieve the actual section in the applicable code edition, scope of work and any cross-referenced administrative/technical requirements before selecting an approach.
Possible exceptions and legal limitations: Exceptions and thresholds are section-specific; no permit or repair exemption is presumed merely from this reference. Eligibility is not established merely because the excerpt uses a word such as “repair”, “permit”, “cellar”, or “occupied”. Refer to NYC DOB construction codes.
Specific conditions mentioned in this inspector wording
1. Demolition, structural removal or excavation
Investigative test: Determine work stage, support and public/adjoining safeguards; assess whether stop-work, temporary protection and engineered plans are necessary.
Evidence matched to this issue: Dated sequence of work, preconstruction surveys, approved demolition/excavation plans, underpinning/shoring details and trade inspection reports.
Boundary / potential counterexample: Removal of finishes differs from load-bearing demolition; do not infer an approved scope from general photos.
2. Zoning, site use or regulated sign
Investigative test: Identify zoning lot/district and exact installation or use; check approved surveys, permitted dimensions, occupancy use and applicable zoning map date.
Evidence matched to this issue: Survey and zoning analysis, dated dimensioned photographs, approved drawings and any relevant prior permit, variance or grandfathering documentation.
Boundary / potential counterexample: Grandfathered status or variance cannot be presumed from an older installation without lawful-history proof.
Inspector wording mapped to testable facts
Passage 1 — FAILURE TO PROVIDE PROTECTION AT SIDES OF EXCAVATION.
This recorded passage identifies a question about demolition, structural removal or excavation, not a proven final determination. Determine work stage, support and public/adjoining safeguards; assess whether stop-work, temporary protection and engineered plans are necessary. Removal of finishes differs from load-bearing demolition; do not infer an approved scope from general photos.
Passage 2 — AT TIME OF INSPECTION, OBSERVED NO SHORING FOR EXCAVATED PIT/BERM APPROX. 5'FT(L) X 20'FT(W), AND 8'FT DEEP LOCATED AT REAR Y…
This recorded passage identifies a question about demolition, structural removal or excavation, not a proven final determination. Determine work stage, support and public/adjoining safeguards; assess whether stop-work, temporary protection and engineered plans are necessary. Removal of finishes differs from load-bearing demolition; do not infer an approved scope from general photos.
Identifiers, locations, measurements and chronology to verify
- Identified building exposure: 3
- Use a labeled elevation/key plan and matching photos so findings relate to the correct building face.
- Stated dimensions: 5', 20', 8'
- Re-measure in the field, show the measurement origin on an annotated photo and compare the relevant code threshold.
Case-specific correction decision tree
Branch A — physical or documentary defect persists: evaluate risk and the controlling technical text, then select correction. Branch B — it was already compliant on the cited date: marshal contemporaneous approved records and site evidence. Branch C — scope, code edition or identification is wrong: prepare a fact-by-fact comparison to the actual summons and cited regulation before advancing a defense or revised filing.
First targeted evidence collection: Dated sequence of work, preconstruction surveys, approved demolition/excavation plans, underpinning/shoring details and trade inspection reports. This is an investigative request, not a claim that the work or evidence already exists.
Editorial closure of the shortened allegation — NOT source text
Verbatim excerpt ends: “VATED PIT/BERM APPROX. 5'FT(L) X 20'FT(W), AND 8'FT DEEP LOCATED AT REAR YARD OF THE BUILDING EXPOSURE 3.”. Non-source editorial completion (conditional reconstruction, not a quotation): “The allegation appears to concern demolition, structural removal or excavation; whether additional observations, directions, dates, measurements or exceptions followed is unknown and must be checked in the original summons.”
No missing words, dates, measurements, liability conclusion or regulatory remedy have been invented. Even if the final syllable looks obvious, completing it as a purported inspector quotation would misstate an official record.
Response, certification and closing evidence
A hearing defense, correction of the underlying condition, a DOB AEU Certificate of Correction and payment of an imposed penalty are distinct questions. Retrieve the summons and confirm the OATH hearing or outcome and DOB violation status. Under current DOB guidance, Certificate of Correction review requests are made in DOB NOW: Safety → Violations & Notices of Deficiency; submitter/certifier signatures and evidence requirements are case-specific. Refer to Certificate of Correction instructions.
Source record limitations: The dataset does not authenticate who inspected the property, why inspection started, whether a defense succeeded, which contractor made repairs or whether AEU later accepted a correction. Do not turn this example into a claimed client success story or an invented inspection history.
Primary authority and fact-check links
- OATH Summons Finder instructions (download actual summons) — enter summons 39203085L and obtain the signed notice.
- NYC DOB construction codes — verify law wording and any exception.
- BIS / DOB NOW record limitations — older BIS violations may not be in DOB NOW.
- Certificate of Correction instructions — review current COC procedure, signatures and evidence.
Related library and official records
Official sources: Search DOB records · DOB summonses · Certificate of Correction FAQs · OATH hearing options · Construction codes
Need a resolution plan tied to the full summons?
Building Violation LLC can review the violation wording, permits, drawings, correction evidence and available OATH hearing procedures. A web example is not a determination of compliance for any property.